View Full Version : what is the best way to remove grease and dirt
mikey's250sx
06-30-2005, 06:21 PM
is there a magic chemical i can buy or am i just going to need a case of engine degreaser and a gallon of simple green? gotta strip the frame down to get ready for painting.
Hornetpowerspor
06-30-2005, 07:36 PM
Take it to the local car wash, and for about 1 dollar you can have your motor spotless. Most car washes have an Engine Degrease mode on the dial, turn it there and blast away.
r00sty
06-30-2005, 07:45 PM
Oven cleaner...... :welcome:
Billy Golightly
06-30-2005, 07:59 PM
castrol super clean...just wear rubber gloves. :D
ATCwithdrawals
06-30-2005, 08:16 PM
I like the stuff called "Greased Lightning", seems to work well on light grease.
twgranger
06-30-2005, 08:52 PM
I use a steamer power washer that runs on diesel fuel, it works great!! Just have to watch out for the stickers.
hrc85250r
07-01-2005, 12:19 AM
parts brush and carb cleaner, then use the hose, and THEN the car wash.
83185s
07-01-2005, 12:46 AM
uh gas and a wire brush goes along way...maybe you could pour colman fuel on it and stand really far away and light it and then see all the paint and greas burn off...then im sure the car was with that engine degreaser would get the rest...that stuff dont work well without help..unless its really light grease or brake dust
double r
07-01-2005, 01:11 AM
brake cleaner, and then water, works wonders. WD-40 will also take grease off pretty good.
AZ250R
07-01-2005, 03:03 PM
Go ride it in the DUNES for a couple of days, IMO! :p
Spray 9 and a pressure washer...works good...or varsol and a brush lol
BIGCRIP28
07-01-2005, 06:15 PM
Go ride it in the DUNES for a couple of days, IMO! :p
free sand blasting :p
Huffa
07-01-2005, 08:49 PM
For grease and grim I think Easy Off oven cleaner works the best.
BigRedRunner
07-02-2005, 03:06 PM
Burn it off!!! I took to a company here in town called Fimco (they make Ag sprayers and stuff) and they put my frame and swing arm in an oven and actually burned off the paint and grime before sanding blasting it. Then it was put on the line with the products they normally make to be powdercoated. I feel like I stole something because they did it for $65.
nouseforaname90
07-02-2005, 03:16 PM
Well there is this stuff called Power Out (I think thats what its called.. I'll check in a little bit), that works very well. Its a grease remover, and its very powerful stuff. Just spray it on, and let it sit.. as long as you don't care about your paint.. it will eat paint right off..
trikerider2oo7
07-02-2005, 04:33 PM
i put castrol superclean all over my whole bike about 10mins before i wash it. leave it set and pressure wash it all off. and i dont need gloves. never hurt me before
nouseforaname90
07-03-2005, 11:57 PM
Its not called power out.. its called Power Dissolver by Dawn. Very powerful. As long as you dont care about losing the paint on your trike, use it..
monster 84r
07-22-2005, 02:33 AM
i just use diesel motor degreaser, stufs pretty cheap, and it works good on a warm motor with dirt and grime.
oddball3
07-22-2005, 10:41 AM
Krud Kutter, home depot got it. I spray it on and power wash it off.
trikes4life
07-22-2005, 03:06 PM
i Belive there is a cleaner called purple that is hard to find but it does wonders.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.