who is good at rebuilding brakes.

[Macs]

i obviously suck. so, if you are good, i will pay you to rebuild my system or sell me yours. know matter what i do, they will not work. also if anyone has a step by step giude for an 83R let me know.

[hrc85250r]

they wont work at all? they should at least work a little....

[ATCWRENCH]

are the brakes for you 83R? If so I can rebuild the whole braking system for that, front and rear caliper and master cylinder. If you think you can trust me I will do it for you

[Dirtcrasher]

Sometimes the hardest part abot rebuilding brakes is simply getting them apart. All the pins get seized in the aluminum and it's hard to get them apart without damaging anything. You have to make some jigs up to get things pressed apart. I get everything spotless and use 600 grit cloth to smooth things out after lightly honing the master and caliper piston bores. I use a dremel with a wire wheel to get the bore where the seals rest cleaned up. As long as the pistons are not scored and that they are in spec then your all set. The most frustrating part is getting them properly bled when your done. Don't make it harder than it is, it's simply fluid pushing something out, thats it - don't give up, you can do it!

[Macs]

were is a good place to buy rebuild kits for the rear master cylinder and caliper?

[Power_Ram100]

I found this place but never ordered anything from them. I guess its worth a shot. They have brake caliper rebuild kits. Check it out

Front Kit:http://www.crosstec.com/wc.dll?ctwp~iteminquiry~1001~1002~H333071

Rear Kit: http://www.crosstec.com/wc.dll?ctwp~iteminquiry~1001~1002~H333083

[kilabeez0]

hey great link! can anyone do a step by step on how to disassemble?