CR 250 intake boot on ATC R?

[Dynofox]

A local fellow board member/triker (250RNUT) hooked me up with a 85 cr 250 intake boot (thanks again!) since I needed a new intake boot for my 86 250r (cracked). It looks to be a little shorter but all the mounting holes line right up. Anyone else use a cr intake on their 250r? Anything to look out for?

[bigredhead]

as long as everything lines up and fits.. and seals properly... can't see why it would be a problem.

Does the carb end up at a weird angle ( ie: not level ) ..??? otherwise.. rock on !

[Dynofox]

I haven't installed it yet, will tonight though. The only differance I see is the rubber boot is not quite as long.

[3leggeddog]

let us know.i got that 92 cr motor going into a 86r and i bought a atc intake cause i didn't think the cr intake would work.it looked to me as though it would aim the carb to far up.let me know how it turns out.the cr intake i have is a boyseen rad valve and would prefer to use that over a stock intake.

[Dynofox]

The 85 cr 250 boot does NOT work. The rubber is too short so there is a big gap between the carb and intake boot from the air box. It does bolt up so if you were not using the air box it would be fine.

[3leggeddog]

heres what you do for that.

go to lowes,or a hardware store.get a 2 inch plumbing coupler.it will be rubber,and will slide right over the carb and airbox boot.eliminating the gap.i had to do this on my 85r when i put the 38mm a/s on it.let me know if you got any more ?'s