View Full Version : 250sx/200x conversion steering stops
mad_max
02-21-2005, 11:49 PM
My bud Matt fabbed up these stops and welded them to the frame. I think they look factory. I decided not to cannabalize the good 200X frame for the stops. I also replaced the races after welding was completed.
http://www.terraworld.net/mikemax/IMG_0019.JPG
http://www.terraworld.net/mikemax/IMG_0020.JPG
asc180
02-22-2005, 08:24 AM
Let me know if it works and give me some dimensions. I have to do the same thing as I can't find the 200x stops.
chris200x
02-22-2005, 08:38 AM
My 200x only has one longer stop on the front. Did you ever hear of anyone trimming it down on both sides? I guess that would tighten the turning radius a bit.
straight pipe
02-22-2005, 09:21 AM
good job!! i got a 200x skeleton yesterday for the front end.the frame looks twisted so for me i have my probs removing it to install on my sx. great idea!!
Dirtcrasher
02-22-2005, 10:35 PM
Let me know if it works and give me some dimensions. I have to do the same thing as I can't find the 200x stops.
Best thing to do is grab a cereal box top and start trimming one up. Soon as it's what you like as far as hitting the stop parallel and following the radius of the frame head, grab a piece of 1/4 inch cold rolled steel and go to town.
I put the tank on and took measurements from there while I turned to each side.
Looks good Max, will do the job just fine.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.