PDA

View Full Version : oil out the crank case breather?


vartiak15
01-31-2005, 09:07 PM
ok on my 200x im getting oil shooting out the crank case breather. little squirts of it. all over. what is causing this. to mich oil?
short4stuff
01-31-2005, 09:48 PM
well I would check that first... did you put too much oil? ..
Hmm if its not that .. I am sorta confused .. unless you have alot of blow by. which you shouldnt seeing as you just did your topend .. unless you did it wrong.
vartiak15
01-31-2005, 10:12 PM
im going to pull the case cover off and check the oil filter too. than drain the oil out and put in lil by lil to make it perfect.
03 ORANGE SHEE
01-31-2005, 11:28 PM
on a pinger , thats a blown crank seal
vartiak15
01-31-2005, 11:31 PM
what. what seal woudl this be? all were replaced. got a parts fish pic and number of the seal.
HaggLE
02-01-2005, 09:19 PM
on a pinger , thats a blown crank seal

If it was a crank seal it would be leaking oil from the crank. I think you are confusing things with 2 strokes.

It is normal for a little bit of oil to come out of the breather but not an excessive amount. You NEED a piece of hose on the breather so that if it pushes oil out it can have the chance to suck it back in as well. It also stops dirt, sand and mud from getting in. Check it by running the host into a clear plastic bottle like a drink bottle and go for a ride. If it is definately still outputting alot of oil it can be caused by a number of things.

-Alot of long high reving like road racing
-bent conrod
-badly worn rings
-restriction in the breather path

Good luck.
vartiak15
02-01-2005, 09:55 PM
whats a conrod? crank rod? where would i check for the restriction in the breather path. its got a new piston. it does shoot it out i have that tube on there i would always notice a lil oil sitting under the bike but it was where that hose was. it would leak out. like some would build up in there than sit and slowly drip out.
MTS
02-01-2005, 10:12 PM
how much oil do you put in it???
vartiak15
02-01-2005, 10:20 PM
about 1.3 quarts
HaggLE
02-02-2005, 12:06 AM
conrod=connecting rod=the ROD that CONNECTS the piston to the crank
vartiak15
02-02-2005, 08:16 AM
its a new rod so i hope it inst bent.
84250r
02-02-2005, 06:58 PM
Did you find your problem?
03 ORANGE SHEE
02-02-2005, 07:10 PM
i read his post wrong
vartiak15
02-02-2005, 10:17 PM
didnt find it yet. been at school and basketball. ill get to it sunday. what should i look for. first thing im going to do is drain it out and only put in a quart or untill it is level.
Tri-ZNate
02-02-2005, 10:54 PM
ok on my 200x im getting oil shooting out the crank case breather. little squirts of it. all over. what is causing this. to mich oil?


My 250sx would do that when I popped wheelies because I had too much oil.