Huffa
01-29-2005, 01:32 PM
I had both machines at one time and up in the attic found a perfect headlight guard that I believe was optinal equipment on one of them. Might fit both......I just don't know at this point. It is rectanguler to fit around the whole plastic headlight body.
The inside measurments are L = 6&3/4 & W = 4&1/4.
Your headlight should measure just a bit smaller then this if this is to slide over it. It mounts by way of each headlight bolt on the side that holds the plastic headlight body in place.
Hope someone can help.
Thanks!
The inside measurments are L = 6&3/4 & W = 4&1/4.
Your headlight should measure just a bit smaller then this if this is to slide over it. It mounts by way of each headlight bolt on the side that holds the plastic headlight body in place.
Hope someone can help.
Thanks!