90 Psi !!!

[bigredhead]

on an 82 . 200 :w00t:

How bad is that !! :p

Starts and runs like a champ tho... i started , ran it on idle for 5 minutes or so.. could have been warmed up a bit more. Gonna try it again after running around the yard some another night.

I find that if i run it on 1/2 choke it rev's up better than with no choke .. once fully warmed up it idles and runs without choke.. but with 1/2 choke.. it runs better ! :D

[MTS]

heh you did do this with the decomp lever disconnected right? 90psi is really low......

[andy]

I just tore down my top end and it was at 85psi on my 125. It woulnt even turn over.

[bigredhead]

It's got no decomp lever cable, however i did not check the arm position, but i beleive it's spring loaded to close.. gotta check that.

[grundlegrabber]

Check the valve clearance. AS the valve seats wear in, the valve stem gets closer to the rocker arm, eventually preventing the valves from closing completely, thus causing a loss of compression.