250r swingarm rebuild parts needed

[markdb420]

Anyone know where I can get the parts associated with the swingarm pivot area being rebuilt? I need the 52109-HA2-305 BUSH, PIVOT THRUST(4 needed), 52141-HA2-000 COLLAR(2 needed), SWINGARM, 91253-HA2-005 DUST SEAL(4 needed), and 52144-HA2-005 CAP, DUST SEAL(4 needed). I have priced them on service Hondas website and they are expensive. Does anyone know where to get an aftermarket kit for these items? Just checking before I dump alot of money into the OEM parts.

Thanks for any help guys! :TrikesOwn

[Mr. Sandman]

Try http://www.cal-atv.com they've got a ton of new and used 250R parts.

[Xowner]

check out the pivot works kit for a trx its got everything i think the only thing diffrent is a collar in their that you have to cut down a bit if not pm dads over on www.3wheeler.org on their fourms and i bet he can set you up!

[markdb420]

Yeah CalATV is higher than service honda is. Does anyone make an aftermarket kit for this pivot rebuild?

[Mr. Sandman]

Well that sucks! I have seen kits in the Dennis Kirk and Rocky Mountain ATV catalogs, but don't know if they still offer one for the 250R.

[markdb420]

Rocky mountain has the 86-87 TRX 250r kit for $42.99. That should fit as all the parts numbers forthe OEM parts ar the same as the ATC parts. What do yall think?

[Mr. Sandman]

Here you go, Rocky Mountain ATV offers a kit with everything for the 86-87 TRX 250R (I think they're the same as the ATC) for $41.99. It's part #281-09-1

[Mr. Sandman]

You beat me to it.

[markdb420]

Ok I see that is the all balls kit and they also have apivot works kit for 42.99, which is better?

[Mr. Sandman]

It looks like there's 2 to choose from for only $1 difference. All Balls or Pivot Works.

[Mr. Sandman]

No experience with either. How much is the OEM?

[markdb420]

OEM is well ove $100 for all that is needed. :mad:

[Mr. Sandman]

I'm sure the aftermarket is just as good and worth the saved $$$.

[markdb420]

Yeah, I am sure it is worth the saved money. Thanks for all the help. I had a really screwed up pivot area on my 86 and I needed those to get them in before we paint the sandblasted swingarm. This 86 was in terrible shape. Motor was even worse that the swingarm, LOL!

[chris200x]

I got my swingarm bearing kit from dads on ebay for $35 it came with everything you need bearings,caps,washers, etc. even sold me a swingarm bolt for $10 I had to use the sawsall to get mine off! I do not know if he is a member of this board but he does post on .org alot He,s ou of New Hampshire and is a real good guy

[Jeb]

I used a pivot works kit in mine. It installed with no problems. I payed 40 for it got it off ebay.