110 cylinder head need help

[martyrsxblood]

i just re bored my honda 110 84 and ran when i took it apart and put a new p/k camshaft in it but when i tired putting the cylinder head back on it wouldnt slide on right . it dosent connect right please help

[martyrsxblood]

can anyone please help its really making me mad

[martyrsxblood]

dosent anyone know anthing about the 110 cylinder head

[ClayW]

Hey,

Sorry no one has responded. More info would be needed for someone to help you. I would help ya, but I have never had one torn down. I have an 83 that I will be tearing down in a month or so, but until then I dont know

ClayW

[bigred110]

The jug or the head doesn't line up correctly?

[wilb67]

Did you damage the dowel pin that lines up the head to the cylinder? If you bent the dowel,it won't slide on easy. How far will the head go down before it binds up?

[martyrsxblood]

the cylinder head . top goes down but the bottom dosent . does it matter where the dowel pin is at? mines on the top right.

[wilb67]

there are two crank case dowels. Both go on the right side studs.( looking at the studs while sitting on the trike) Also if you removed the cylinder studs,you have "A" studs and "B" studs. put them back in their proper place.

[martyrsxblood]

is the right front stud on the top or bottom and is the left rear stud top or bottom? how do i know which is A or B can i buy new ones how much do you think they cost?

[wilb67]

I'm sorry, on the cylinder, the dowels are both on the right side(while sitting on trike). I was thinking of the head. sorry. Let me check my book on stud location, i'll be right back.

[wilb67]

The "A" studs go on the left side(if looking at studs while sitting on the trike) which are the shorter studs. The "B" stud goes on the right side which are the longer studs. You can buy the studs from www.bikebandit.com for $5.44 each.

[martyrsxblood]

thanks ! you have good info lots of help!!!

[martyrsxblood]

wait i got confused can you tell me the location of the dowel pins on the head and cylinder and how many are the i'm going to buy new ones

[martyrsxblood]

does any body have dowel pins they can sell me and were the a and b studs go 9in what place do i put them0

[wilb67]

Go to www.bikebandit.com
click on OEM parts,they will prompt you to put in year,make,and model. Then click on oil pump crankcase or what ever you want to see and the schematic will pop up so you can see for yourself what goes where. Hope this helps! :D
-Will.