View Full Version : little question.
mevaters
08-04-2004, 06:09 PM
Hey, The right foot peg on the z is really loose and falling off. The bolts have a little room to wiggle in there. I think that the tread where the foot pegs screw into the frame are worn down. I am just going to try a little bit larger bolt tomorrow to see if that works. If not did anyone on here have the same problem and if so How did you fix it. Is there a drill bit attachment that can make the holes a little bite bigger and make new tread? Or would you have to take this to a machine shop? Thanks in advance Rob.
84250r
08-04-2004, 06:56 PM
Use a tap for a bigger hole and pick what threads you want it to be(i.e. 18,20,24,32,etc..or mm's)
almac16
08-04-2004, 08:09 PM
Yeah ....... get yourself a tap and die set.........they are very handy,....I've used mine a lot !
mevaters
08-04-2004, 09:00 PM
Thanks for the help. The hardware store has tap and die sets in stock, I will pick one up tomorrow.
smokinp
08-04-2004, 09:07 PM
try putting some washers on it...
bigredhead
08-05-2004, 10:55 AM
a nut a bolt and locktite.
or
jbweld !!!!
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.