how to get holes lined up for new maier fenders? 2 pics

[82-8250R]

since these come with no holes pre-drilled what is the easiest way for me to get all of these lined up for the front and rear fenders on my 82 R. Also update pics will come soon. White fenders 2 tone blue and white seat done. After it comes out of the shop and is running it will be stripped down and painted the same metallic blue as the seat. Should be pretty sweet. :TrikesOwn :Bounce :beer

[vartiak15]

for my front i had the tripple off and flip it up side down and then put a lil bit of lip stick on the tops of holes and then lined up the fender and pressed it down then pulled it off and i had the lil rings from the lip stick on the fender showing me where to drill.

[82-8250R]

come on i know someof you guys have done this i dont want to f*** it up.

[3forlife]

If you look real close under the right light you can see where the original holes were filled before the fender was molded, thats how I did it for my 110.

[twgranger]

My front fender for my Z came with holes and that was from maier.

[82-8250R]

ok i got the rear done but ill have to wait on the front till i get the bike back so i can fit it right.

Thanks guys