PDA

View Full Version : Urgent Exaust Stud Question


atcmatt
06-05-2004, 12:18 AM
Gday,

Pulled my head off today but the lower exaust stud bolt snapped off, leavign about a half centimetre left. I have had it in the vice trying to turn it but it will only give a small bit and then stop again. The top one was threaded and came out easily. Is this one pressed in or threaded also? How do i get the trailprotrailprotrailprotrailprotrailprotrailprotrailpro out?

Thanks,

Matt
Xowner
06-05-2004, 12:46 AM
i took my 350X ones to a machine shop i heard you could weld a nut on their
atcmatt
06-05-2004, 01:12 AM
D/W i got it off at last.

Just needed a bit of heat and lubricant.

Matt
TheOlderFox
06-05-2004, 11:51 PM
It would be threaded on there. I run into this all the time. I just a little PB blaster lube and a low torch flame. If that doesn't work, use an easy-out screw extractor before you mess things up too much. If there is enough to weld a nut onto so you can back it out that way, go for that one too.