Rear carrier rebuild

[smokeyhonda]

I'm rebuilding the rear end of my honda 200, I insalled a grease fitting and new bearings. The problem is the new bearings, I think I seated them too deeply. The spacer in the middle now turns with the inner bearings- you spin one bearing and the spacer spins the other. do I have to back out the bearings? Will it loosen up on its own?

[C W.]

dont wory about it.let it rip. :rolleyes:

[sandrooster]

Supposed to be that way.

[Howdy]

The spacer is suppost to move with the bearings. You said it was so that means you did it correctly. :Bounce

Howdy

[smokeyhonda]

Non-problem, I like that. Thanks for the info. When I tore it apart the spacer was all over the place, so I thought it was suppposed to be loose. Thanks again.