goki starter

[chuck]

I received my goki starter i won off of ebay last night. the install was a breaze, it was easier because all the componites were assembled. i have to go today and get a battery and a battery cable and i should on the road. it is on the road but now it will have an electric start. this is on my 200S.
i won the starter kit for $6 and some change. the guy also thru in a rear brake assembly and some other wire set up that through me off because i spent so much time trying to figure out what it went for but it was for something else.
a big ol thanks goes out to johnny-aka ejc042. he took the time to fax me 20 pages of instructions for the stater that the guy did not have.

[ejc042]

Glad to hear you got it installed. Now we just need to get to gether to ride sometime.

[chuck]

some time this summer we will get together for sure. i just need to get my new carb that i am buying from whiterider, i think that is his name.
my 200x will run great untill the float bowl gets to full and floads out the cylinder. i just wait a minute and fire her back up and ride untill the next time. my wife sure likes to spray me with mud while i am trying to restart it.

[cliff2302]

chuck, what your describing sounds more like your float level is too low in your carb. if your carb flooded enough to stall the motor while its running, i dont think it would start again. but it your float level is too low, your bowl will empty without being re-filled quick enough, which would make it stall out, and the start up in a little bit. just my opinion, but you ride the machine and know it better than me. good luck

[350x'inNY]

YOu got a Goki starter kit for $6 ? :eek:

Darn! He have one for a 350X?

Bruce

[chuck]

ooops i ment to say $46 and some change, still a good deal.
as far as the float goes, you maybe be right but i know i can not adjust my float seeing as it is all platic. i was assuming the float being to high, to low sounds good to me, i just wish i could adjust it.

[chuck]

the other reason i was saying it was to high is because it will spray gas out some little vent tubes that face the air cleaner assembly, i was told and think that is becasue there is to much gas getting in there, but maybe i dont really know. i got a new one on the way.

[cliff2302]

your probably right then. good luck with it!