View Full Version : I got bored one day.....
Honda1986ATC350X
03-18-2004, 08:52 AM
and decided to disassemble my 86 350X. Being that I have no experience in doing this, what should I be careful of???? Are there cetain things that need to be checked while I'm down to engine and frame???? I will be attempting to put new Barnett fiber and steel clutch plates in it sometime next week. Any advice on what I should do would be greatly appreciated because I am just wrenching in the dark.
Thanks
Ted
Honda1986ATC350X
03-18-2004, 06:49 PM
so.... any advice would be welcome... .... ... .... ....
86250RZ
03-18-2004, 07:25 PM
Not sure about the steel plates but the fiber ones need to be soaked in oil over night or they will be slipping in no time. I learned this the hard way.
350XXX
03-18-2004, 07:56 PM
the best advise i can give you is go to the honda dealer and buy a 350X service manual. they are less than $40 and can save you much $$$.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.