Tri z pv intake boot

[6spdls1z28]

Does anyone make the intake boots from a pv top end that curves so the filter doesn’t hit the pipe. Mine works but is still too close to my liking.


Sent from my iPhone using Tapatalk

[El Camexican]

I looked for something aftermarket a year or two back and found nothing. There is a PV thread on here by Neverlift you should checkout if you haven’t. He plumbed his Tri-Z using silicone hose. Came out pretty nice.

[6spdls1z28]

I looked for something aftermarket a year or two back and found nothing. There is a PV thread on here by Neverlift you should checkout if you haven’t. He plumbed his Tri-Z using silicone hose. Came out pretty nice.

I’ll look into it. Did you ever finish yours?


Sent from my iPhone using Tapatalk

[6spdls1z28]

I looked for something aftermarket a year or two back and found nothing. There is a PV thread on here by Neverlift you should checkout if you haven’t. He plumbed his Tri-Z using silicone hose. Came out pretty nice.

I just looked up his I remember seeing it before. I made one just like it but it completely killed the power of the bike running that. So I went back to a filter straight off the carb. Plus it had a weird sound to it that way.


Sent from my iPhone using Tapatalk

[6spdls1z28]

Mine is right against it.https://uploads.tapatalk-cdn.com/20230428/e445e33e2a3c13ec8c3b84f96c8649d0.jpg
Keep exhaust wrap around it. Been like this for a while hasn’t melted the filter.


Sent from my iPhone using Tapatalk

[atc300r]

UPP makes an offset for a Blaster 38 mill carb.

[6spdls1z28]

UPP makes an offset for a Blaster 38 mill carb.

Wonder if I can get them to make some for us powervalved guys.


Sent from my iPhone using Tapatalk

[atc300r]

Will a 85-86 250r intake work.

[El Camexican]

I’ll look into it. Did you ever finish yours?


Sent from my iPhone using Tapatalk

Nope, got distracted. Motor is done, just need to bolt the head on. Was thinking about getting the outter o-ring done rather than using sealant. Need to finish that up.

[6spdls1z28]

Nope, got distracted. Motor is done, just need to bolt the head on. Was thinking about getting the outter o-ring done rather than using sealant. Need to finish that up.

I can tell you the pv top end makes the z a monster


Sent from my iPhone using Tapatalk

[6spdls1z28]

Will a 85-86 250r intake work.

I’m not sure it looks really similar to the yz boot. Would you happen to have some measurements and pictures of one


Sent from my iPhone using Tapatalk

[6spdls1z28]

I contacted upp to see if they would make any. I highly doubt it though.


Sent from my iPhone using Tapatalk

[6spdls1z28]

Upp contact me back they might have interest in making some I’ll post if they say yes!


Sent from my iPhone using Tapatalk