86 plastics on 84 200x

[burg28]

I was wondering if anyone has attempted this. I was thinking about doing it I just dont know how much work is involved. I'm pretty sure the mounts are different. Any insight would be helpful. Mike

[jason200x]

for the fornt fender, you have to drill them, only drill the two holes in the front. do not tighten them ver much, and leave the stock pads where they are, if you dril holes in te back itll point the frotn of the fender down and makes it look bad, the stock pads will still pad it.

for the rear fenders, wel it simpley doesnt work. no matter what ou do it wont work.