ps2fixer
12-25-2019, 11:43 PM
A while back I had a request to post this if I found it, can't remember who was looking for the spec, but I ran across it today. This is from the 84 TRX200 on page 6-7 which is effectively the same engine as the ATC200ES. The gap spec should be very similar for all of the similar engines, and likely not a bad number to base for other models as well.
0.4-0.65mm (0.015-0.025in)
https://i.gyazo.com/375f04ada7b8a1b068d254b00930ba77.png
Hopefully someone finds this useful. Also don't forget to check that the rotor moves freely and springs back well while you're in that area of the engine.
0.4-0.65mm (0.015-0.025in)
https://i.gyazo.com/375f04ada7b8a1b068d254b00930ba77.png
Hopefully someone finds this useful. Also don't forget to check that the rotor moves freely and springs back well while you're in that area of the engine.