View Full Version : 200x intake o-ring
whiteman350x
11-06-2019, 09:55 AM
Does anyone know the specs on the o-ring between the intake and head on an 84 200x (od- id - and thickness)?
shortline10
11-06-2019, 11:23 AM
O-ring (33.5x3.0)
This is the spec Honda gives out
whiteman350x
11-06-2019, 11:57 AM
is the 33.5 id or od?
shortline10
11-06-2019, 01:11 PM
If their is no inner or outer its probably the center measurement so just - and + 1.5mm
You can just measure your manifold and get the answer as well :)
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.