PDA

View Full Version : what is wrong



bornonthreewheels
02-19-2004, 10:55 PM
i just checked my piston in my 125m becouse it was smokeing real bad and oil was comeing out of my exaust. but to my suprise the piston and rings where fine. so what could be the problem?

hondaATCman
02-19-2004, 10:58 PM
Did you make sure the rings weren't lined up with each other?

TRI-Zbrian
02-19-2004, 10:59 PM
i had this happen on my 200s engine... litteraly i watche dthe oil oooz out of the exaust pipe... what causes this?

Chopperdad
02-19-2004, 11:02 PM
Oil Leaking down the valve guides probably.

thefox
02-19-2004, 11:04 PM
I think that it would be the valve guide seals too.

Domingo
02-19-2004, 11:42 PM
Told you it was probably something with your valves...but do you beleive me?? No.....Dale doesn't know anything...

84250r
02-20-2004, 02:13 AM
Told you it was probably something with your valves...but do you beleive me?? No.....Dale doesn't know anything...

Wow,,,and where is this coming from?

Mobular
02-20-2004, 03:27 AM
The bore may be suspect. Check for glazing of the walls, or even just plain old wear allowing too much piston to cylinder clearance, thus decreasing ring tension and allowing excess oil to not be properly removed from the wall. Also look for nicks in the oil rings.