PDA

View Full Version : Carb Question Hurry!!!


RyanRX7
02-13-2004, 10:57 PM
Ok I need a response fast, is a pilot jes supposed to have a hole straight through??? The jet next to the main one.........On one end it has small holes in the sides of the tip but are you supposed to be able to see light through it????
RyanRX7
02-13-2004, 10:58 PM
O yea I'm trying to tunnel trgouh it with a pin and it won't go that's why I ask
J.D.
02-13-2004, 11:05 PM
Yes, it's a small hole all the way through. A pin may be too big to get through though, so blow it out with compressed air.
nitekrawler
02-13-2004, 11:08 PM
Yes, it's a small hole all the way through. A pin may be too big to get through though, so blow it out with compressed air.

He is right 8)
nitekrawler
02-13-2004, 11:09 PM
Need jets go here
http://www.rageperformance.com/carburetorparts.asp
TimSr
02-13-2004, 11:19 PM
Ok I need a response fast, is a pilot jes supposed to have a hole straight through??? The jet next to the main one.........On one end it has small holes in the sides of the tip but are you supposed to be able to see light through it????

Its the other way around. The main jet is the jet with one hole through it. The longer one that looks like a spaghetti strainer on the end is the pilot jet.
nitekrawler
02-13-2004, 11:20 PM
Ok I need a response fast, is a pilot jes supposed to have a hole straight through??? The jet next to the main one.........On one end it has small holes in the sides of the tip but are you supposed to be able to see light through it????

Its the other way around. The main jet is the jet with one hole through it. The longer one that looks like a spaghetti strainer on the end is the pilot jet.

OPPS :!: He is right, 110%
RyanRX7
02-13-2004, 11:33 PM
Yes the main jet is in the middle, next to it is the pilot jet and the adjustment screw is next to that. There is a nice clear hole in the min jet, the pilot (which is for idle RPM fuel delivery, which happens to be why I'm working on the carb in the first place) I can fit a pin in both ends just fine ( about 1/8 into the jet) but not all the way through.
nitekrawler
02-14-2004, 12:14 AM
I have one, what size you need? I have one for my 250r 82 Atc
I have a 50 pilot and 148 main jet available :-D Let me know
RyanRX7
02-14-2004, 01:29 AM
welp problem solved, SSJ3Goku was correct. It did have a hole all the way through, and a pin was too large. I ended up clearing it out with the wire inside a twist tie. This solved my problem if any of you had read my other post about my trike nor wanting to idle. The pilot jet was seriously clogged keeping fuel from being delivered at low RPM. Can't wait to test her out tomorrow. Only one question left, what was that (starter jet) so damn had to move when i reinstalled it??? It stuck in for a while, it was a very tight fit.