El Camexican
12-18-2017, 11:32 PM
Any thoughts on this?
Two cylinders, same make and model bike, same part # cast into them, identical in all ways but one. The one in the first picture has a 3mm hole above the exhaust port and the second one doesn’t. I always assumed that hole was there to keep positive pressure on the power valve to keep it from fluttering, but why wouldn’t the second cylinder have the same hole? I have no reason that hole was put there by anyone other than the factory.
248508248509
Two cylinders, same make and model bike, same part # cast into them, identical in all ways but one. The one in the first picture has a 3mm hole above the exhaust port and the second one doesn’t. I always assumed that hole was there to keep positive pressure on the power valve to keep it from fluttering, but why wouldn’t the second cylinder have the same hole? I have no reason that hole was put there by anyone other than the factory.
248508248509