View Full Version : Pic of tri -z clutch cable at motor
smrover1
07-05-2017, 08:14 PM
Could someone please post up a pic how clutch cable attaches to the tab on the motor with that little clip I just can't figure it out I have a new cable and clip
3 Wheel Drive
07-05-2017, 11:01 PM
#10 slides into the crank case, your cable sits in the clip and attaches to the actuator arm (#27 in 2nd pic).
http://www.cheapcycleparts.com/oemparts/l/yam/50038894f870021f60a09b94/1985-ytz250n-parts?dropdown=t
244774244775
smrover1
07-06-2017, 06:29 PM
#10 slides into the crank case, your cable sits in the clip and attaches to the actuator arm (#27 in 2nd pic).
http://www.cheapcycleparts.com/oemparts/l/yam/50038894f870021f60a09b94/1985-ytz250n-parts?dropdown=t
244774244775
so the hole in the clip goes through the cable also where the clip goes on the motor is at a slant and not alot of room
3 Wheel Drive
07-06-2017, 07:08 PM
At the bottom of the #10 cable holder it's flat and slides into the slot in the crank case. The round hole in the holder should sit flat against the sling shot looking U shaped part as in the picture.
244778244779244780
smrover1
07-07-2017, 03:24 PM
Thanks that is the pics I needed
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.