HEAD09
06-24-2017, 10:45 AM
Hey guys!
I need help! I'll give you the synopsis. Well I was pulling the studs out of the head,
And I was just done doing the last one and had too much crap in my hands and dropper the cylinder head on the floor !!!! Wtf! So I put a dent in the surface area where the cool head mounts to it! Right where stud is o I took it to the local machine shop because were the cool head O-ring runs it wouldn't seat I asked him to go down .005 and he called me said it wouldn't work so he went down 001 at a time and we got to .011 and I just put it back together and saw the piston slightly above the surface area so I put the cool head on without the O-rings and there's not hitting but, i'm worried about expansion from heat that I might have a problem.....
I have Weisco piston on their 50 mm over
so guys running a cool head if they get their cylinder heads decked before and had no problems please chime in and let me know thanks! And if it will work I'm I going to have a problem with running only race gas?
I need help! I'll give you the synopsis. Well I was pulling the studs out of the head,
And I was just done doing the last one and had too much crap in my hands and dropper the cylinder head on the floor !!!! Wtf! So I put a dent in the surface area where the cool head mounts to it! Right where stud is o I took it to the local machine shop because were the cool head O-ring runs it wouldn't seat I asked him to go down .005 and he called me said it wouldn't work so he went down 001 at a time and we got to .011 and I just put it back together and saw the piston slightly above the surface area so I put the cool head on without the O-rings and there's not hitting but, i'm worried about expansion from heat that I might have a problem.....
I have Weisco piston on their 50 mm over
so guys running a cool head if they get their cylinder heads decked before and had no problems please chime in and let me know thanks! And if it will work I'm I going to have a problem with running only race gas?