View Full Version : 85 200X caliper piston doesn't go in
atc1985
02-08-2004, 07:55 PM
I followed the 1985 200X shop manual instructions on
how to change the rear brake pads but the
caliper piston won't go in, any ideas? :rolleyes:
Howdy
02-08-2004, 08:02 PM
Did you try adjusting the parking brake screw? If not loosen up the nut and back the bolt off some to allow some clearence.
Howdy
nitekrawler
02-08-2004, 08:50 PM
I followed the 1985 200X shop manual instructions on
how to change the rear brake pads but the
caliper piston won't go in, any ideas? :rolleyes:
Take the pressure out of the line (remove the brake fluid)
atc1985
02-08-2004, 08:54 PM
Thanks for the advice !!!
I'll give it a try.
nitekrawler
02-08-2004, 10:04 PM
Leave the Banjo bolts off, then push the piston back
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.