Ran into a problem with thrust bushings hope someone can help

[seth6025]

So I got my new bearing and seal kit for the swingarm today and what I didn't notice until now is that the thrust bearings are missing from the swingarm and are no longer available from Honda. I looked on ebay and only found one but I need all 4. I did find a all balls kit for a 1985 that comes with them. Does anyone know if those would be the same thrust bearings? Mine is a 1983. The part numbers I need are
52127-964-003 and
52129-964-000
Would just those small end bushing be even close? If not im f***** I think cause I can't find any online

[seth6025]

Actually now I see the part numbers are different so I guess they wont fit. Anyone know where I could get these parts or someone that makes them aftermarket? My build is now at a hault

[yaegerb]

Contact BKM on the boards and have him make you a set of 2nd gen delrin bushings for the front pivot section. He's making me a set right now and he will have extra material to make you a set. These bushings replace parts 8, 24, 7, 6 and 5 from both sides of the swingarm at the link below. They are great bushings for sure.

http://www.partzilla.com/parts/search/Honda/ATV/1983/ATC250R+A/SWINGARM+83-84/parts.html

[bkm]

I can check tonight and see if I'll have enough material left over after yeagerb's are finished. If so $55 shipped for a set.

Sent from my SM-G900V using Tapatalk

[Dirtcrasher]

Unless someone knows otherwise, I'm certain they are chicken to make on my or anyone's lathe....

[seth6025]

I can check tonight and see if I'll have enough material left over after yeagerb's are finished. If so $55 shipped for a set.

Sent from my SM-G900V using Tapatalk

Right on...let me know for sure. I found a set from a old swingarm an hour away from me. I might have to go with those for the time being but I would still like to know if you end up with some left over. Thanks

[bkm]

Right on...let me know for sure. I found a set from a old swingarm an hour away from me. I might have to go with those for the time being but I would still like to know if you end up with some left over. Thanks
I don't have enough this go around, but if you wanted a set, I could order some. Just let me know.

[bkm]

I went ahead and just ordered some more material for the second gen 250r.

Sent from my SM-G900V using Tapatalk