200x Suspension deminsions

[plkmonster2]

I need a few demensions on the 200x suspension. Ok, here we go:
* How long is the rear shock? From bolt hole to bolt hole.
* What is the diameter of the front forks?
* How far are the forks spaced apart? As in, how far apart does the triple tee spread them out?

Thanks Everyone. Need some input for some suspension mods on my 225dr.

[Ride_Red]

Was just passing through the site and saw your post.....went out to the garage and this is what i got from my 84 200x:

Rear shock length from bolt hole to bolt hole was 12 inches.

front forks were 1 1/4

and from the center of both forks was exactly 11 inches.

Hope that helps you out.

[plkmonster2]

Thanks a bunch! I appreciate it! BTW, Welcome to the Board!! :-D :-D :-D

[short4stuff]

how are you going to do the mods ??? considering the dr has the shaft, ??? if you change the angle you are going to mess something up... If it works out for you I may attempt it though :D

[plkmonster2]

Thats why I'm getting the length of the shock. I want a bit softer shock, but the same length...

[short4stuff]

o ok thats cool, let me know if you attempt any of the mods, I just got my DR going again today.

[plkmonster2]

I just noticed how long the shock was on my dr. 16 1/2 inches!! :shock: thats hella long! any other shock that long?? The front forks are 1 3/16, and 27 inches long from the top to the bolt hole, and spaced out 12 7/8 inches. How long are the 200x forks?