BarnBoy
08-29-2016, 07:01 PM
Hi,
I just installed a new clutch into my ATC200M. I put the side cover back on and torqued it up, and then attempted to adjust the clutch. However, I have the clutch adjusting screw set right I think (all the way in, then 1/4 turn out), but there is still a few inches of play in the shifter lever. If I hold the lever up with the side cover off, and push in on the clutch lifter cam, and the ball is lined up between the 2 grooves, it will adjust fine. But if I try to hold the lever so the ball is set correctly, and put the cover back on, it seems to work, until I tighten up the adjusting screw lock nut and try and shift the gear. When I push down to shift, then raise it up, it goes back to having 2-3 inches of play. Any ideas on what could be wrong? I double checked that everything is all together properly, and have no parts left over. I am not sure why it is doing this. Hopefully its something simple.
Thanks
I just installed a new clutch into my ATC200M. I put the side cover back on and torqued it up, and then attempted to adjust the clutch. However, I have the clutch adjusting screw set right I think (all the way in, then 1/4 turn out), but there is still a few inches of play in the shifter lever. If I hold the lever up with the side cover off, and push in on the clutch lifter cam, and the ball is lined up between the 2 grooves, it will adjust fine. But if I try to hold the lever so the ball is set correctly, and put the cover back on, it seems to work, until I tighten up the adjusting screw lock nut and try and shift the gear. When I push down to shift, then raise it up, it goes back to having 2-3 inches of play. Any ideas on what could be wrong? I double checked that everything is all together properly, and have no parts left over. I am not sure why it is doing this. Hopefully its something simple.
Thanks