110 performance parts needed

[parkerwarn]

I am looking for old used stroker cranks for 90's and 110's, used performance cams, old high compression pistons and anything performance for a 90 or 110. CONDITION DOES NOT MATTER. LMK what you've got.
Thanks

[hawaiirider]

unbolt stock motor, sell on ebay, bolt in pirahana motor, mods complete

[81ATC185S]

Too bad the pirahana motor isnt a direct swap and is unreliable, and is kick start, and has no high low.

[1979atc]

Could be done but a lot of mods needed to the frame.

[hawaiirider]

high lows just dead weight unless used for utility.
didn't know the pirahana wasn't a bolt it, heard it really rips from everyone who bought one though.
had a hard time modding my 110, owned it from age 12 to 22 wouldn't step up to a bigger trike because I liked it and there were no bigger trikes in s.c. to be found.
I put a lot of $ in mine, cam, carb, piston, cobra pipe... my buddys stock ragged out klt 160 would flat out smoke it still... then I overjumped mine and broke it clean in half...
just saying if you expect a lot out of a 110 it will show you what it was intended for, a kid or learning adult..

[briano]

Too bad the pirahana motor isnt a direct swap and is unreliable, and is kick start, and has no high low.

How do you know the motor is unreliable? I had one in a 70, great running and would rip. Did you know a recoil conversion can be done quite easily also, I'm an idiot and I made my own. And, with a bracket that is easily obtainable from Dr. Atv, the motor is a bolt in. Before you reply with all of your info, make sure you are correct first.

To the original poster. Contact Shortline10, he is the 90 and 110 guru.

[oscarmayer]

www.tboltusa.com will have a ton of stuff compatible. Call and talk to Vince. he is a great guy and will certainly be able to assist.

[hawaiirider]

Just take in what I said about my modded 110, they are designed for kids and learning adults - if you push the bikes limits she will let loose... wish I had a pic of mine broken clean in half still! the frame/axle housing etc wont take the beating the modded motor gives you, I learned that firsthand. my bud broke his in half too with a stock motor just by jumping it too often
gusset/reinforce the frame to counteract your mods for safetys sake

[1979atc]

Be better off to get a aftermarket frame if your going to be doing all of that. My opinion for as much as they want for those motors I would stick with the honda engine, not a big fan of them Chinese engines. These frames are just stamped metal. I've seen a lot of frames snap in half by the fender latch.

[hawaiirider]

theres a guy in the classifieds selling frames mods etc

[Daddio]

Good luck with your search. There is stuff out there, but I'm afraid it won't be cheap. I saw a stroker crank for one on ebay for $599.