86waterpumper
07-20-2015, 03:35 PM
Ok recently I bought a nice condition (cosmetic wise) 1979 honda 110 off craigslist. The problem is that the yahoo I bought it from had been running ethanol gas in it. Now I have stuck floats, leaking bowl overflow etc. I bought a carb rebuild kit. I have worked on big reds and two strokes but not a 110 before.
Here is my question. How in the heck do you loosen the carburetor bolt that sits to the inside? There is no way to get any sort of open end wrench, or socket on it doesn't matter what type of swivel you use. There isn't enough room for the socket itself to sit there. Do people heat up wrenches with a torch and make some custom tool or what? No way can I get on it with needle nose pliers even. Do I have to pull the whole intake down at the head to get it?
Here is my question. How in the heck do you loosen the carburetor bolt that sits to the inside? There is no way to get any sort of open end wrench, or socket on it doesn't matter what type of swivel you use. There isn't enough room for the socket itself to sit there. Do people heat up wrenches with a torch and make some custom tool or what? No way can I get on it with needle nose pliers even. Do I have to pull the whole intake down at the head to get it?