87 tecate wiring question

[MIK6]

Hi guys.. im putting together a 2nd 87 T3. My 1st 87 T3 is a mod trike, uses KX ignition.
This is going to be stock. I got a new harness from 3ww store, new switches, ebay key switch and new RickeyStator ignition. The kill switch had the wrong ends, so im looking for how that hooks into harness so i can make it rite and how the key switch hooks in.. the rest i can figure out. I want a T3 w a key.. lmao!
I have my 86 that i can look at for more info but its harness is hacked up.

thanks guys..

[nd4speed]

says 86 87 but looks to just be 86
http://www.3wheelerworld.com/oldsite/files/Wiring/KXT250B1B2x86Thru87.jpg

[fieldy]

What I can tell you is that there were more expensive kill switches that are supposed to be designed and ready to plug into the stock harness. I saw them on 3Bay searching tecate kill switches this past winter. I hope this helps out.

[fieldy]

Bump. K&S technologies from parts giant are the switches I saw. The 86 and 87 are the same kill switch by K&S. If i had an 87 i would want it to look factory. It would be nice to see a picture of how the oem 87 key switch ties in and looks. If not maybe you could see an oem 87 at trikefest. If I can go I will try find out and get a picture and of it.

[MIK6]

Thanks fieldy.. this 87 will be at TF! Lol
My mod 87 is the only trike that as been to every TF! And my mod 86 harness has been hacked into 100 times. Lol

I have it figured out, i did end up going w a OEM key, the really nice kill switch that picked up had no plug ends on it. That is where the confusion came from. 1 side of the kill goes to the coil, so when your looking at the harness it looks like its short 1 connector.
Thanks to everyone that helped out!