karlznet
01-18-2004, 02:02 PM
I was hoping that someone could help me with info on where to start with jetting a 28mm Mikuni flatside carb on a bored and stroked 200x. I have the carb but its missing the slide and needle and by looking at the 280 main jet that is in it, I figure it came off a 2-stroke. I am going to order the slide and needle from Sudco but would like input from someone that has tried this carb before ordering. If anyone has purchased a Mikuni flatslide TM-28 $114.95 from www.pro-flo.com for use on a 200 maybe this would be a good starting point. Any help on this will be greatly appreciated. Thanks.....Karl