How to get hold of Jason hall with Questions about 350x inverted fork kit?

[bushwacker51]

I was wanting to buy one of Jason Halls kits for the inverted forks and was wanting to use the cr125 forks and I saw in the add he said the forks would need to be machined. Need to contact him to see if he provides that service and details about getting the work done. A phone number would be appriciated. Thanks Glenn O.

[MIK6]

I forwarded him a link to this thread on his cel phone..

[Jason Hall]

I sent my phone number to you in a PM :)

[bushwacker51]

I sent my phone number to you in a PM :)

Thank you Jason ill call you. Glenn O.

[NeverLift]

Hey Jason. I am in need of a brake rotor adaptor and axel spacers for a tri-z.

[Jason Hall]

There are So many different offsets. It's hard to tell what you need from a pic, if they are not my clamps I have no idea how to make you the correct adapter or spacers. I can make you spacers and a rotor adapter that will be too wide, and you can space everything where you need it. It's a PITA to center everything up.

[NeverLift]

There are So many different offsets. It's hard to tell what you need from a pic, if they are not my clamps I have no idea how to make you the correct adapter or spacers. I can make you spacers and a rotor adapter that will be too wide, and you can space everything where you need it. It's a PITA to center everything up.

Thanks for the response. I am the 3rd owner of the clamps so I don't know who built them. They did come with the wheel spacers but I will be in need of a rotor adapter. I am ordering CR125 forks/caliper/rotor for the project. I will take pictures of the clamps and post them up maybe you can let me know if they were built by you.

[jhonz]

I forwarded him a link to this thread on his cel phone..
Hey I'm trying to get ahold of Jason as well, I sent him a pm however am not sure he got it! Can you help me get ahold of him concerning 350x inverted fork conversion???thank you!

Sent from my SM-G928V using Tapatalk