NateN34
08-10-2014, 03:52 AM
Hey,
So long story short, I rebuilt my whole engine on my ATC 200. I finally was getting the top end together, when I noticed this:
198566
I am unable to align the dot with the notch up top. It ends up being about a half tooth off... Note that it is perfectly TDC, new timing sprockets, new timing chain, etc.
The only reason I am thinking it is like this, is because the machine shop didn't line it up, when they pressed on the new timing sprocket. So, I decided to assemble it like this picture and will try to start it tomorrow.
My question is; this normal? Will it work fine?
Thanks in advance,
Nate
So long story short, I rebuilt my whole engine on my ATC 200. I finally was getting the top end together, when I noticed this:
198566
I am unable to align the dot with the notch up top. It ends up being about a half tooth off... Note that it is perfectly TDC, new timing sprockets, new timing chain, etc.
The only reason I am thinking it is like this, is because the machine shop didn't line it up, when they pressed on the new timing sprocket. So, I decided to assemble it like this picture and will try to start it tomorrow.
My question is; this normal? Will it work fine?
Thanks in advance,
Nate