Throttle cable trouble

[Bren_downe]

I bought an angle adjuster from JetsRus and need a little advice on how to install it. I've contacted them and they weren't much help. They did say I need to remove the assembly off the end of the cable ( that connects to the carb).
Has anyone ever removed that or installed this? How did you do it?
Dremel? I don't want to just rip it off in fear of shredding the cable wrap.
Thanks in advance!
196675

[Bren_downe]

I got the adjuster off bit can't seem to make this damn 90degree adjuster fit right?
I'm ready to buy a different cable. Any one have any ideas? It's an 82 250r with an 85 R carb(34mm PE).
I need one with the elbow. The 85 cable worked but was a pain in the ass to jet with it so close to the frame.
I talked to motion pro but they want $35 to custom build one and it will be 7 days before it's even out the door.

[danbur55]

if you havent looked already check some of the chinese quad suppliers have different lengths and are usually pretty cheap hope this helps ya out