Prm atc 250r nerf -discontinued?!!

[3wheelrider]

I just got enough $$ saved for these & go on EBAY & the PRM site but listed as no longer available!!!! :mad: .

[Mr. Clean]

Call PRM and ask for Chris. That is probably your best bet to contact them direct.

[3wheelrider]

^^Oh-I sent a message earlier thru EBAY which PRM appears to be the seller on the listing...This just happened within last week I believe. I'll see if I get a reply thru EBAY soon...

[jays375]

I would call them.That is your best bet.Might be out of stock currently is all.

[pipeline triker]

Call them, they are great people to deal with.

[threewheelin-feelin]

didnt they just start selling them like 6 months ago?

[3 Wheel Drive]

194505


I got a set for my tri z! You should get some, we need to get an order going for the Tecates too!

[3wheelrider]

UPDATE: They went back on sale after I contacted them thru EBAY ? (seller is also the manufacturer). I received the nerfs (removed the stock pegs beforehand)- I held them up & was worried they had no chance of bolting up! I was pissed at 1st as I didnt know it would take some bending/pulling/prying, grinding, & of course cursing.:mad:.... If you start the peg bolts 1st, the front & back mounts need persuasion in the right direction. I didnt measure ,-but theyre off what seems like too much.-IMO. ALSO: the right-side nerf front mount tab needed some grinding down to clear my DG pipe. I dont like the way the teeth are cut on the pegs- but oh well.
I really expected it to bolt up-What was I thinking? In the end -They look great (takes getting used to as its odd to see nerfs on a trike) but they are solid -but it took a while to get them on. A extra helping hand could be REALLY helpful. Anyway,- Thought I'd give a heads up. Apparently their jigs needs some adjusting!.... I'll get some pics when I get the R cleaned up from last ride.

[kazander]

the x nerf bars were the same way to bolt up. it took a lot of work to make them fit right. but man they look good and i do like riding with them.

[6speedthumper]

the x nerf bars were the same way to bolt up. it took a lot of work to make them fit right. but man they look good and i do like riding with them.

I had similar issues as you guys when I put them on my 350x. The only mounts I had a problem with were the front two that use the motor mount bolts. Had to do a little tugging and pulling to get them to line up with the bolt holes in the frame. Wasn't too bad. I don't care for the 5/16" bolts they supply for them. Thy should have used the same diameter and grade metric bolts as stock. I think the biggest problem is that no two frames are the same. Between age, and abuse, they have all gotten their own "twist" to them.

[jays375]

My 350x ones mounted up great.

[Samjp22]

Still think they have some leftover or would be willing to make some?

[hatc200x1]

I just bought a 250r set a few weeks ago on Ebay from them, contact them through Ebay and say you need a set, they will get some more made up.

[Samjp22]

Awesome thanks