finished my 200x Tree swap on my250sx, couple questions.

[tree18is]

pictures first
http://i.imgur.com/cEL3o3g.jpg

So you can see the offset.. oops I think I put the spacers in backwards I didn't even think you could do that, flip flopped the sides ya know.

Second I have one of the weld in 1/4 steel steering stops and I do not see how it can work unless I cut it in half and make it limit the left and right movement by using it in two pieces. does anyone have a picture of one installed?

[tree18is]

PS: I used some head bolt washers I had laying around and you wouldn't believe how well the caliper lines up with the rotor!

[MNhondaguy]

A descent piece of steel welded to the head tube on either side in the right spot will work. I welded the whole head tube from an x on mine so I didn't need to fab one.