350x rebild

[ustin666]

hears a few pic of my 2014 350x rebuild just finished putting mu 400ex swing arm an custom axis 450r rear shock whit a 250lb spring. cant wait to try it out. 184334184335184336184337184338184339

[6speedthumper]

Lookin good!

[MojaveRider]

How does the length of the 350X stock swingarm compare to the 400EX swingarm?

[fallguy666]

Yeah,what he said^^^^^

[Dirtcrasher]

I'd like to know as well. The 06 and up 450TRX is about 3"s longer than a stock 350X, 05 and under is closer to stock length.

Trust me, it still turns just fine on a MX course with the added length.

My question is on the width of a 400EX versus the 450TRX. Which needed quite a bit of machining to fit.

Looking good!!

[ustin666]

the 400ex swingarm is a bit longer hears a pic 184609 and the 350x and 400ex axle are the same length. i am putting 1.5 inch spacers each side.

[ustin666]

getting the frame powder coated next weak

[Dirtcrasher]

Make sure the brake master fluid lines clear the right gusset. I would update to a new 450R master as I did; Just needed a way to get the tubing all set.

I believe even the new ones are cheap!!

Good to do before powder.........

[jays375]

A clean nice little master cylinder is off the YZ 450 dirt bike.What shock are you using?

[ustin666]

im using 350x caliper and piston got the 400ex bracket on the 350x caliper. and its a custom axis

[ustin666]

almost got all my parts . i brought my frame to get powder cote should get it in a few days. just got my new piston, crank redone, new crank bearing, new clutch waiting on new 300ex oil pump. and just put 4 new valve and timing chain last year engine should be good fore a other 5 year i hope. i will upload pic as son as possible. now just need to save up money for a ktm 85 front end .

[ustin666]

188172188175188171188174188173almost done just missing the oil pump .