Paging Mickey Dunlap, 350x cam with bearings info

[Xowner]

Looking for some info on putting needle bearings inside the 350x head, Mostly because i have a few heads kicking around that have the surfaces messed up and id like to save them and prevent that from happening again. I seen on one message board where you said at one time you had the cams. So figured might as well put this up and get the info out there incase anyone else needs it Thanks

[bkm]

If Mickey can't help, look into megacycle. I had a 200x engine with a roller cam from them. Pretty slick setup.

[atc007]

He shouldn't be too long responding. Too cold to be out running Mowtos :)

[big specht]

Yea I think megacycle made the cams that where a drop un less the head was really trashed

[Mickey Dunlap]

***********************

[Xowner]

Yes I can build them but my grinds are a lot bigger then the off the shelf stuff. I would have so see how bad the surfaces are to know if I can save the head or not.

So if I was going to use the head in an stock rebuild your cam won't be the choice for that rebuild.

[Mickey Dunlap]

***********************