Polishing cases... How to??

[hondaATCman]

Ok, I got the flywheel off of my 250r and split the cases. I need to know the best way to sand and polish this thing to make it look chrome again so I can paint it.

[TRI-Zbrian]

if you are just painting it then all you need to do it clean it up very well with degreeser then wash all the cleaner off of it and they should be ok to paint also get a bake on type paint it holds up alot longer

[Lots_Of_Nothing]

best solution i have found to get all the old shitty paint off is;

-get paint stripper (i recomend this ZIP strip stuff, any local hardware store should have it)
-pour it in a bucket and let the cases soak for a few minutes
-take the cases out and use a wire brush to knock off all the paint
-dry them off and scrape off leftover paint (shouldnt be much)
-spray with oven cleaner, then rinse with water and let dry.
-sand with a fine grit sandpaper all over the surface to roughen it up..so the paint has a good tooth to stick to
-paint...dry.....paint however many coats you want....
just make sure you use the good quality high temp paint.

[TeCaTe_MaN]

dremel..... :D