NateN34
10-19-2013, 06:22 PM
Hey,
Well I ordered a new oversize piston a few days ago and now have received it. It was dirty,but I cleaned it up and everything looks good. EXCEPT a few things.......
Good dent:
179208
Another small dent:
179209
Nice indentaion of the corner. Note that this creates a nice bur on the side of the piston!
179210
Another angle of the same indentation and bur:
179211
I am no expert on this, but the bur on the side of the piston worries me the most. Note that bur protrudes from the side that would be in contact with the cylinder wall.
So, my question; Is the piston usable or should I return it and get a different one?
Thanks in advance,
Nate
Well I ordered a new oversize piston a few days ago and now have received it. It was dirty,but I cleaned it up and everything looks good. EXCEPT a few things.......
Good dent:
179208
Another small dent:
179209
Nice indentaion of the corner. Note that this creates a nice bur on the side of the piston!
179210
Another angle of the same indentation and bur:
179211
I am no expert on this, but the bur on the side of the piston worries me the most. Note that bur protrudes from the side that would be in contact with the cylinder wall.
So, my question; Is the piston usable or should I return it and get a different one?
Thanks in advance,
Nate