4x150 Wheel Spacers??

[kb0nly]

I see a ton of 4x110 billet aluminum wheel spacers on eBay but none in the 4x150 pattern that the 200 and 185 uses. Anyone know of a source for them in about the same $40-$50 price range you see the other sizes on ebay?

I would like to add about 4" overall to my 200ES rear end. 2" per side. Mainly because the tire chains i run for plowing in the winter time rub the exhaust slightly. I could probably even get by with as little as 1" per side spacing added but i want something strong and reliable like those billet ones on ebay. I haul trailers and do a lot of utility work with my 200ES so i can't do any cheap backyard engineering on this if i do it at all.

Just cant find any 4 on 150 spacers! Hard to believe they are so uncommon.

[dougspcs]

I've looked also in the past..never found such a thing.

[kb0nly]

Dang... Figures!

I know i could probably get some made but the cost would be the hardest part to deal with. The hunt continues...

[trizilla]

i do not know for sure but double check your bolt pattern. some older honda atc's used the 4x130mm pattern, these are not readily available but they can be found. or maybe you could change over to the 4x130mm pattern if your is 4x150 now.

[Jason125m]

Only way I can see putting wheel spacers on is to make some. Get some aluminum or steel, and bust out the drill press!

[kb0nly]

Nope definitely 4x150 on the 200ES, measured and verified... DANG..

Maybe i can find some place that could at least make the pieces to the point that i can drill them and finish it off. I don't know yet, still thinking out loud... LOL Last thing i want to do is mess around with swapping hubs or wheels, etc.. Not going to go that far.