83r rebuild

[250r 83]

Recently had my top end done on my 83r to .080 over. Just need to know what fuel mixture I should use, and proper break in procedure? Normal fuel mixture is 32:1. I was told to use a 40:1 mixture by one person and another told me to use 24:1. Just looking for a second opinion.

[TRI-Zbrian]

for break in id mix it a little rich eather 24 to 1 or 32 to one i wouldnt go any leaner then 32 to 1 right off untill its broke in a bit

[250r 83]

Thanks for the advise Tri-z, just wanted to make sure I do it right because the next time I have to take her in she will need a new sleeve. Just wish I would have known the guy swamped it before he sold it to me.

[TRI-Zbrian]

yeah i had that happen to me on my last tri z got into the engine one day to find out it was already 80 over i was so pissed off :twisted:

[250r 83]

damn liars, I guess the best thing to do if you swamp a trike is to sell it right away instead of taking it apart and removing the sand off of the top of the piston and getting the water out of the bottom end. Now I dont feel so bad about giving him 150$ less than he was asking for it.

[TRI-Zbrian]

lol that sucks lol my old 200s i had way back would float in water you had to hold on to the handle bars so it wouldnt tip over but it held its self up it was funny lol i dont realy go threw deep water on my tri z so i dont have that problem.