View Full Version : Cylinder Porting
NeverLift
05-14-2013, 04:00 PM
I do all of my own porting and use a 1/8 pen style die grinder. I have found it difficult to find good bits at any local stores besides the small sand paper wheels. Any suggestions on where I can get a good variety of bits.
El Camexican
05-14-2013, 04:11 PM
I do all of my own porting and use a 1/8 pen style die grinder. I have found it difficult to find good bits at any local stores besides the small sand paper wheels. Any suggestions on where I can get a good variety of bits.
I just buy the $49.99 200pc kits and toss what I don't use, but if you plan to keep at this I suggest you man up and get the 1/4" stuff, much better selection and quality.
NeverLift
05-14-2013, 04:33 PM
I've got the 1/4" also but the 1/8 is so much nicer to get into tight areas.
El Camexican
05-14-2013, 04:56 PM
I've got the 1/4" also but the 1/8 is so much nicer to get into tight areas.
That's the truth.
atc007
05-14-2013, 05:13 PM
I've always used Craftsmans stuff. Had really good luck with it. As you know,No matter what you use goes fast.. If only all of those old cylinders I did would have been made from the garbage things are made with today! My nights at the bench would have been much shorter :)
barnett468
05-14-2013, 06:40 PM
I do all of my own porting and use a 1/8 pen style die grinder. I have found it difficult to find good bits at any local stores besides the small sand paper wheels. Any suggestions on where I can get a good variety of bits.
Helo
I get mine at any industrial hardware supply store, they have a huge variety White Cap may have them if there's one near you.
NeverLift
05-24-2013, 03:18 PM
Harbor Freight had some good stuff.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.