90crazy
01-02-2013, 10:37 AM
This is a project that I'm throwing together for my cousin. Starting with a Pauter PJ1 frame and a large stroker motor with manual clutch. The forks are from an original flat tracker we picked up a while back. They are shortened around an inch and a half and we had the peg welded on to accept a 125 front brake hub.
Pay no attention to the rear tires. We had the fiberglass atc 70 tank customized to fit this frame. It might hold a half of a gallon of fuel?:crazy:
Here is a link to the motor build.... http://www.3wheelerworld.com/showthread.php/142322-ATC90-Tricked-Out-To-185cc
The yellow trike in the pic is the original flat tracker that we got the front forks off. Also this is where we got the mold for the low pro fenders.:naughty:
Pay no attention to the rear tires. We had the fiberglass atc 70 tank customized to fit this frame. It might hold a half of a gallon of fuel?:crazy:
Here is a link to the motor build.... http://www.3wheelerworld.com/showthread.php/142322-ATC90-Tricked-Out-To-185cc
The yellow trike in the pic is the original flat tracker that we got the front forks off. Also this is where we got the mold for the low pro fenders.:naughty: