Tri-z Clutch

[slippy4]

How far should i tighten the (pressure plate?) theres i think 8 or so bolts with springs on them, and i changed my clutch plates and forgot to see how far in the were adjusted.

[whiteman350x]

Well, I checked boyth my manuals and they did not say. On the hondas the books just say tighten securely. I usuallyrun themdown till the springs bottom then give it a little more. Good luck.

Whiteman

[TRI-Zbrian]

if u break a finger off of trailprotrailpro pressure plate by chance ive got three extras here so just give me a shout if u need one.

[03 ORANGE SHEE]

6flbs. BUT NO MORE!!! the springs will keep them tight ,or you could break one off.

[mike from long island]

when i put new clutches in my Z i used a 1/4 inch rachet. tightened them down just snug then gave about a 1/2 turn on each. the springs will hold pressure on the bolts. or try using a small 1/4 torgue wrench. dont use a 3/8 it is too big and wont calibrate correctly. youll torgue down more with a bigger torgue wrench. just be careful i broke one off. but thanksfully i had extras. good luck

[slippy4]

alright, ill have to try it and see what i can break,lol, thanks