wrench report phase 2 mods

[hondadozer3851]

OK so I am planning on doin the phase 2 mod to my 85 tri z but I am unable to find the article for the specs can someone who has done this mod that could post exactly wat was done and post pictures or post a link to it. Also would I be able to run a 40mm Carb with this complete set up
Thanks james

[XxMurdocxX]

Which brand of carb are you wanting to run? Here is a link to the wrench report. http://www.quadpit.com/mags/1985/3-4w-action/yam-wrench-report-01.htm

[hondadozer3851]

It is a mikuni same one i sent a pic of to you and thanks for the link

[XxMurdocxX]

O yeah....... well the 38mm that was on the z that had the wrench report done on it, minus the exhaust. It had an old school dg on it with a spark arrested answer 2 equalizer silencer that mosh saved from going in the trash lol.

[hondadozer3851]

Would I be able to run the 40 after the mods are done without worrying about blowing the motor up

[XxMurdocxX]

40mm is fine i just wouldn't go with a round slide. It won't have the response, crispness or top end of a flat slided carb.