Deathrocket
05-06-2012, 09:18 AM
2nd thread because its a different question,
k here's what i got, its a 38mm pj kehin, its running rich after sitting, carb has been apart and cleaned about 20 times trying to figure this one out, floats are set right and are good, first the needle / seat was in question as it was flooding out the vent tubes, replaced the needle, it stopped doing that, the jet needle that's attached to the slide is bent slightly, working on replacing that, but other then that its set right and still running rich, since the carb was flooding, is it possible that its fuel in the bottom of the crank case that's making it run rich? last time I had an abundance of fuel in the case I took the intake off and sprayed compressed air in the intake while kicking it over with the plug out, but I don't have air anymore, so how many kicks would it take to clear the case out? and is there a better way to do this?
k here's what i got, its a 38mm pj kehin, its running rich after sitting, carb has been apart and cleaned about 20 times trying to figure this one out, floats are set right and are good, first the needle / seat was in question as it was flooding out the vent tubes, replaced the needle, it stopped doing that, the jet needle that's attached to the slide is bent slightly, working on replacing that, but other then that its set right and still running rich, since the carb was flooding, is it possible that its fuel in the bottom of the crank case that's making it run rich? last time I had an abundance of fuel in the case I took the intake off and sprayed compressed air in the intake while kicking it over with the plug out, but I don't have air anymore, so how many kicks would it take to clear the case out? and is there a better way to do this?