Honda 200 nut

[tulsamike3434]

on the one-way clutch there is a big nut on the honsa site is says it's a 22mm so I went and bought a 22 mm deep socket and its way to small?? anyone know what size it is?


part no. 13
http://partsfinder.onlinemicrofiche.com/hondaoftulsa/Honda_OEM/HondaATV.asp?Type=13&A=9&B=9

http://i1093.photobucket.com/albums/i434/mikesatcshop/8bac6f02.jpg

[malibulvr]

You need to pick up a cheap set of Vernier Calipers...set the sucker to mm and take a measurement.

[muthey]

mike here is the funny thing about nut and bolt sizes when they call it a 22 mm or a 7/8, they are talking about the threaded area not the wrench size, makes it a pain sometimes.

[rdlsz24]

Can you use a crescent wrench on that?

Rob

[oscarmayer]

i think it's a 41-42mm deep socket. i had to go buy one myself when i redid my bigred.

[Dirtcrasher]

I think you should grab a set of impact sockets.

I've seen the set on sale at Sears for 19,95$ Even the Harbor freight one's have held mainly because of the thicknesses.

Of course you'll still need a cheap air compresor.............

[Howdy]

if I remember correctly the Clymers manual says 30mm deep well socket.
Howdy

[tulsamike3434]

Yep Howdy it was a 30mm! so after 2 trips the the ace hardware store I got it off! lol thanks for all the help!

[muthey]

I hate to admit it but I have a lage sized vise grip that I used on nuts like that, I get it on them then give it a couple of good taps witha 3lbs mini sledge and they come right off.

[Scootertrash]

Crescent wrenches?? Vise grips??? http://www.smileyvault.com/albums/misc/smiley-vault-misc-075.gif (http://www.smileyvault.com/)

You can buy a 30mm deep socket for less that 20.00 or an impact socket for less than 30.00. Some peoples kids. Buy 'em books, send'em to skool.......

[oscarmayer]

LOL Scooter!
yea i have all those tools from over the years of work I have done so i tend to forget he size. I just know by sight now, this socket goes here. lol talk about too much time on my hands!!

[malibulvr]

mike here is the funny thing about nut and bolt sizes when they call it a 22 mm or a 7/8, they are talking about the threaded area not the wrench size, makes it a pain sometimes.

I beg to differ. The standard nut measures (.75") and fits into a 3/4" socket and the metric nut measures (.524") which converts to a little over to a 13mm socket.

146576 146578
146577 146579

[1984 honda 200s]

Unstake, place large screw driver into stater cup, use vise grip and hammer clock wise.. comes off nicely