View Full Version : how do i change a rocker arm?
ytm200steve
04-10-2012, 01:11 PM
hi i was wondering how to get the rocker arm out of my ytm200 i have the cam out and the valve covers off but how do i remove the rocker arm? ;/
Dirtcrasher
04-10-2012, 04:51 PM
You have to get the shaft out. There is always a way to get it out, just take a better look......
If the shaft is beat up, then you'll need rockers and shafts. (journals)
Make sure you are at TDC on the compression cycle so the rockers are loose a bit.
ytm200steve
04-10-2012, 08:31 PM
its like a bolt with no end on it the cam is out the rockers are free
trizilla
04-10-2012, 08:52 PM
i think you have to thread a long bolt into the end of the rocker shaft. yamaha had a tool for it i think but i have used a bolt before.
MonroeMike
04-10-2012, 10:33 PM
Page 79-82.
http://72.52.143.80/~trikes/ytm200&225-fm200_clymer_manual.pdf
If you put the rocker arm shafts in the freezer for a while, before reassembly, they go in easier.
ytm200steve
04-11-2012, 11:27 AM
how do i use a bolt i found one that fit
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.